HOME CAPABILITIES CUSTOMER SERVICE SURFACE PREPARATION
AEROSOL LUBRICANTS
MOLY
PTFE
ANOTIC COATINGS
ANODIZING
HARD ANODIZING
CHEMICAL/ABRASION
RESISTANT
CONVERSION
COOKWARE
DRY FILM LUBRICANTS
DURILLIUM B
DURILLUIM N
EXCALIBUR
FOOD EQUIPMENT
MEDICAL
PAINT
PHOSPHATING
PLATING
POLYURETHANE
POWDER
PVC
RELEASE
RUBBER
SPECIALTY
URETHANE
VINYL
WS 2
| AEROSOL LUBRICANTS |
| PERMALON® 327 |
| GENERAL PURPOSE DRY LUBRICANT WITH PTFE |
| PHYSICAL CHARACTERISTICS | ||
 |
Lubricant | Modified PTFE |
| Binder | Proprietary Thermoplastic | |
| Dry Time | Immediate | |
| Functional Temperature Range | -300° to 500° F |
|
| Melting Peak Temperature, Solids | 608° + or - 18° F |
|
| Melt Flow Rate, g/10 min. (ASTM D 1238) | greater than 1 | |
| Softening Point of Film | Greater than 510° F | |
| Net Weight Per Aerosol Can | 14 oz. | |
| Net Volume Per Aerosol Can | 20 oz. | |
| Color | White Translucent | |
| Coefficient of Friction | 0.06 -0.09 Static | |
| Max. Operating Temperature | 150° F | |
| Intermittent Temperature to | 240° F | |
| Typical Cure Thickness | 0.0002 to 0.0007 inches | |
| ABOUT PERMALON 327 |
| Permalon 327 contains PTFE that was specifically
developed for on the job application. It produces a low friction, permanent, non-stick,
and antistatic surface. It is long lasting and does not require frequent respraying.
Its chemical and physical properties are distinctly different from silicone oils and waxes. Permalon 327 works best on continuous, prolonged light load lubrication points such as in vending machines, conveyors, hinges, door locks, zippers screw threads, saws and woodworking tools. It is compatible with most materials including wood, metal, fabric and most plastic and rubber compounds. Permalon 327 is bonded to the surface with a specially developed thermoplastic resin binder that is long lasting (cures to the touch in five minutes) and achieves maximum bond strength and performance characteristics after about two hours at room temperature. For improved adhesion, parts coated with Permalon327 may be heated from 250° F to 500° F for 10 to 15 minutes. |
| LIMITATIONS OF PERMALON 327 |
| Permalon 327 is moderately resistant to some inorganic corrosives such as sulfuric acid
and sodium hydroxide; but it should not be considered as a protective coating against these corrosives. Avoid
use with organic solvents, esters, ketones, and alcohols. Permeable plastics, wood and fabric materials will often absorb Permalon 327 and dimensionally increase in size. Close tolerance parts made of these materials should be tested before use to determine dimensional change. Absorption into a material often can result in higher bond strength and longer wear life. |
| CALL (330) 535 - 9246 TO REQUEST INFORMATION ABOUT RECEIVING PERMALON 327 |
| GET TO KNOW THE USES OF PERMALON 327 |